![]() ![]() The (default) gateway should be set to the IP address of the StrideLinx router. The subnet could for example be "192.168.140", meaning the last figure ".1" can vary anywhere from 1 to 254 as long as it's different from the StrideLinx router. The subnet mask needs to be the same as the StrideLinx router, which is usually 255.255.255.0. The IP address needs to share the subnet of your StrideLinx router but cannot match their exact IP address. ![]() Enter your device's IP address, subnet mask, and (default) gateway under the header "IP protocol".If you have already done so, skip the first 2 steps. To connect to your Siemens controller in LOGO!Soft Comfort, you first need add your device to your project. This chapter shows you how to connect to your Siemens controller using: Remotely connect to your Siemens controller Your Siemens controller is now ready for remote access. Your configuration is now being loaded into the Siemens controller. Press once the appropriate actions are selected. If you are unable to download to the device, try pressing in the bottom right corner or changing an action in the right column. A new window named "Load preview" opens.Once a device is found you can download the new configuration by pressing.If TIA Portal can't find your device, but you know the device's IP address, you can manually enter its IP address in the field highlighted below. This is opens a new window that allows you to search for your device by pressing.Select the device name in the project tree on the left again and click on the " download to device"-icon at the top.Enter in the controller’s IP address, subnet mask, and (default) gateway under the header "IP protocol".Double click the controller or right-click and select.Once you have opened your project in TIA Portal, open the in the project tree on the left.Lastly, you have to download your settings to the controller by pressing the "PC -> LOGO"-icon, highlighted below.Here you can set the controller’s IP address, subnet mask, and default gateway in the > tab.Open the settings by pressing the gear-icon of the LOGO! controller.Once connected, you can configure the IP address of the LOGO! controller. If LOGO!Soft Comfort is unable to find your LOGO! controller, you can try to connect to your controller's default IP address: 192.168.0.1 or 192.168.0.2. Here you can enter the controller’s IP address, subnet mask, and (default) gateway by navigating up/down.Navigate to using the up/down arrow keys and press.You can set the IP address directly at the controller, using the built-in screen and keys, following the next steps: This chapter shows you how to configure your Siemens controller for remote access using: Remotely connect to your Siemens controller.Once that's done, you can remotely connect to it. This article will help you to remotely connect to your Siemens device using the StrideLinx Cloud to set up a secure remote connection.įirst you'll have to properly configure your controller. View our " Establish a VPN connection"-guide for details. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |